NEC QX-S5500G Series - Page 89

Installation Guide
QX-S5500G Series Ethernet Switches
6. Upgrading software
6-18
3. Set XMODEM protocol parameters
0. Return to boot menu
Enter your choice(0-3):
2) Enter 1 to set the TFTP parameters.
Load File Name :update.ipe
Server IP Address :192.168.0.3
Local IP Address :192.168.0.2
Subnet Mask :255.255.255.0
Gateway IP Address :0.0.0.0
Table 6-6 TFTP parameter description
Item Description
Load File Name
Name of the file to download (for example, update.ipe).
Server IP Address
IP address of the TFTP server (for example, 192.168.0.3).
Local IP Address
IP address of the switch (for example, 192.168.0.2).
Subnet Mask
Subnet mask of the switch (for example, 255.255.255.0).
Gateway IP Address
IP address of the gateway (in this example, no gateway is required
because the server and the switch are on the same subnet).

NOTE:
 To use the default setting for a field, press Enter without entering any value.
 If the switch and the server are on different subnets, you must specify a gateway address for the switch.
3) Enter all required parameters, and enter Y to confirm the settings. The following
prompt appears:
Are you sure to download file to flash? Yes or No (Y/N):Y
4) Enter Y to start downloading the image file. To return to the Boot menu without
downloading the upgrade file, enter N.
Loading......................................................................
.............................................................................
.............................................................................
................................................................Done!