NEC QX-S5526P User Manual

80 pages

To Next Page

To Previous Page

Installation Guide

QX-S5500 Series Ethernet Switches

Starting and Configuring the Switch

6) Click OK after setting the serial port parameters and the system enters the following

interface.

Figure 4-5 HyperTerminal window

7) Click Properties in the HyperTerminal window to enter the properties window. Click

Settings to enter the following properties setting window, set the emulation to VT100,

and then click OK.

Figure 4-6 Set terminal emulation in properties setting window

4-4

Questions and Answers:

Need help?

Do you have a question about the NEC QX-S5526P and is the answer not in the manual?

General