QX-S5500 Series Ethernet Switches
4
Starting and Configuring the Switch
Decompress
Image........................................................................
.............................................................................
.............................................................................
.............................................................................
.............................................................................
.............................................................................
..............................................................OK!
Starting at 0x80100000...
Initialize LS55LTSF........................OK!
SDRAM fast selftest........................OK!
Flash fast selftest........................OK!
CPLD selftest..............................OK!
Switch chip selftest.......................OK!
Port 1 has no module
Port 2 has no module
Port 3 has no module
Port 4 has no module
PHY selftest...............................OK!
Please check port leds...............FINISHED!
User interface aux0 is available.
Press ENTER to get started.
The appearance of "Press ENTER to get started" indicates that the automatic startup of the
switch is completed.
Press Enter. The following prompt is displayed:
<QX>
You can configure the switch now.
NOTE:
QX-S5500 series provide abundant command views.
4-10
To Next Page
Loading...
