Install the ISDN PRI Card
Quick Install Guide – SL2100 with ISDN PRI Trunks rev 1.1 13
3- Install the CPU Card
The SL2100 chassis does not have any CPU card pre-installed, you install the card of your choice.
There are two CPU card available:
SL2100 Main Processor Board
• VoIPDB Daughter Board Connector : 1
• EXIFB Daughter Board Connector : 1
• SD Card Slot : 1
• Built-in 4ch of VRS (Not supported for VM without SDVML/SDVMS)
• Built-in 8ch VOIP resources
The hardware is same as IP7EU-CPU-C1.
The feature Includes:
• Built-in 4ch of VRS/InMail voicemail
• 4pc of SL2100 IP TRUNK-01 LIC
• 4pc of SL2100 IP EXT-01 LIC
Ensure the SL2100 system is powered off before removing or inserting the CPU card.
Fit the memory backup battery (CR2032 type)
The + symbol must be on top, as shown below.
Fit the optional items to the CPU card, if applicable:
IP7WW-SDVMS-C1 /
P7WW-SDVML-C1
SD Card for VRS/VM (InMail) Storage 15/20 hour
System Expansion Bus Daughter Board (mount to CPU)
• 2 Bus connectors for Expansion Chassis
• Additional Telephony Resources
• VRS/VM (InMail) Channels expansion (up to 16ch)
• Analog Modem (V.34)
VoIP GW Daughter Board (mount to CPU) 16ch VOIP resources, maximum
128ch with licenses
Refer to the Quick Install Guide for the type of terminals you will be connecting:
SL2100 Quick Install Guide – InMail Voicemail
SL2100 Quick install Guide – VoIP
Note – Both CPU cards may not be available in your region.
To Next Page
Loading...
