Configure the SL2100
Quick Install Guide – SL2100 with ISDN PRI Trunks rev 1.1 37
Automatic Night Mode Schedule
Night modes are used to adjust the incoming ring assignment of the SL2100. Mode 1 (Day) and Mode 2 (Night)
are used within the Initial Setup Wizard, additional modes can be added via this screen. The example below has
Mode 3 used for lunch period.
From the Chassis View click the Trunk port you want to configure
Within the Properties pane click the Night Service Schedule button
Enable the schedule to begin editing and use Automatic Night Modes schedule on the SL2100.
Double click the name of each mode to edit the name .
Tip – Leave the name of Day empty (blank) otherwise all phones will display the text Day on the display during
normal working hours. (Day is shown on this screen shot only for your help).
Click the colour box of the mode and then click within the weekly grid to change the mode. Click Apply to save
your changes.
Change the resolution of the grid to view 1/15/20/30/60 minute grid.
Check the ‘Show holiday schedule’ box if you want to setup fixed holiday days within each year.
Note – Automatic or Manual Night Mode operation can be used simultaneously or independently.
Tip – Setup Programmable Function Keys if the customer is using Manual Night mode selection.
Function Keys can be setup for each mode or you can have a single key that toggles Day-Night-Day.
To Next Page
Loading...
