Unpack the SL2100
Quick Install Guide – SL2100 with ISDN PRI Trunks rev 1.1 8
1- Unpack the SL2100 System
SL2100 Chassis unit
1 x SL2100 system
1 x Wall mounting template
1 x Power cord (selected regions)
4 x Fixing screws (M4.1 x 25mm)
SL2100 CPU card
1 x CPU card
1 x Lithium battery (CR2032)
SL2100 Extension Interface card
1 x Interface card
SL2100 1PRIDB card
1 x 1PRIDB card
1 x Screw & spacers
Additional Items Required:
Cross head screwdriver.
Utility knife or small cutters to remove the plastic knockouts
4 Wall fixing plugs suitable for the type of wall.
Solid wire for extending telephone cabling:
Recommended cable type: Twisted pair (CW1308 or similar specification)
Conductor diameter: 0.4 to 0.6 mm
Maximum cable length: (with 0.5 mm diameter cable)
SL2100 system telephone – 300 metres
Normal telephone (SLT) – 1125 metres
If you need to extend the exchange line cables:
ISDN30 lines must usually be extended by the Network Provider
To Next Page
Loading...
