AudioCodes Mediant E-SBC 18 Document #: LTRT-12530
NEC SV8100 IP-PBX & BroadCloud SIP Trunk
14. To route incoming calls using the DDI Translation tables, configure the SIP trunks as
DID types in Programming command 22-02:
Figure 3-10: Incoming Trunk Routing Type
15. Using the '01 – Dial-in Receive Digits' field, configure the number of received DID/DDI
digits from the SIP carrier. In most cases this can be configured as six digits. If more
than six digits are received from the carrier, the last six digits are used for call routing.
Figure 3-11: DDI Receive Configuration
To Next Page
Loading...
