Configuration Note 3. Configuring NEC SV8100 IP-PBX
Version 7.0 17 AudioCodes Mediant E-SBC
12. Route outgoing trunk digits to the E-SBC in the 10-23: IP System Interconnection
Setup programming command. The shown configuration routes all dialed numbers to
the E-SBC as dialed. The IP address used is the internal LAN interface of the E-SBC.
Figure 3-8: SIP Interconnection setup
13. Optionally reduce the '03 - External Call Inter-digit Time' for outgoing calls:
Figure 3-9: Inter-digit timer for external calls
To Next Page
Loading...
