AudioCodes Mediant E-SBC 16 Document #: LTRT-12530
NEC SV8100 IP-PBX & BroadCloud SIP Trunk
8. From the '28 – Audio Capacity Priority' drop-down list, select your codec preference.
9. From the '32 – DTMF Relay Mode' drop-down list, select RFC2833.
Figure 3-6: Audio Codec Priority and DTMF Relay Settings
10. Using the 84-14: SIP Trunk Basic Setup Programming command, in the
'07 – Session Timer value' field, enter the correct value.
Note: Failure to set this value may result in calls being disconnected after 60 minutes.
11. In the '17 – Moved Temporarily Support ' field, enter 302 Return.
Figure 3-7: Session Refresh Timer
To Next Page
Loading...
