NEC SV9100 - Sending Single User Instant Messages

Page19of60

Conference (continued)
Single Line Telephone
1. Establish Intercom or trunk call.
2. Hookflash and dial #1.
3. Dial extension you want to add.
- OR -
Access trunk call.
- OR -
Retrieve call from Park orbit.
4. Hookflash and repeat step 3 to add more parties.
- OR -
Hookflash twice to set up the Conference.
To Split (alternate) between the parties in Conference:
Multiline Terminal
1. Press Conf (Transfer) or Conference key
2. Dial Split service code (794).
* Repeat this procedure to alternate between the remaining parties in the
Conference. Press the Conf softkey or press Conf twice to set up the Conference again.
Single Line Telephone
1. Hookflash and dial 794.
* Repeat this procedure to alternate between the remaining parties in the Conference.
Hookflash twice to set up the Conference again.