NEC SV9100 - Supervised Call Transfer; Performing a Supervised Transfer

Page35of60

Message Waiting
Operation
To leave a Message Waiting:
1. Call busy or unanswered extension.
2. Dial 0 or press the Message Waiting key
3. Hang up.
With multiline terminal telephones, the Message Waiting LED lights.
To answer a Message Waiting:
When you have a message, your Message Waiting LED flashes fast for multiline terminals.
1. At the multiline terminal, press Speaker and dial 0.
- OR -
Press the Message Waiting key
- OR -
At the single line telephone, lift the handset and dial 0.
If the called extension does not answer, dial 0 or press your Message Waiting key to
automatically leave them a message.
Normally, your Message Waiting LED goes out. If it continues to flash, you have new messages
in your Voice Mail mailbox or a new General Message. See “To check your messages” below.
To cancel all your Messages Waiting:
This includes messages you have left for other extensions and messages other extension have left
for you.
1. At the multiline terminal, press Speaker.
- OR -
At the single line telephone, lift the handset.
2. Dial 773.
3. Hang up.