NEC SV9100 - Station Name Assignment

Page55of60

Station Name Assignment – User Programmable (continued)
Operation
Refer to Table 2-8 Keys for Entering Names for and explanation for using the keypad to enter names.
Use this keypad digit . . .
W
hen you want to. . .
1 Enter characters:
1 @ [ ¥ ] ^ _ ` { | } Æ ¨ Á À Â Ã Ç É Ê ì ó
2 Enter characters: A-C, a-c, 2.
3 Enter characters: D-F, d-f, 3.
4 Enter characters: G-I,
g
-i, 4.
5 Enter characters: J-L, j-
l
, 5.
6 Enter characters: M-O, m-o, 6.
7 Enter characters: P-S, p-s, 7.
8 Enter characters: T-
V
, t-
v
, 8.
9 Enter characters:
W
-Z,
w
-z, 9.
0 Enter characters:
0 ! “ # $ % & ’ ( ) ô Õ ú ä ö ü
* Enter characters:
* + , - . / : ; < = > ? B E S ¢ £
# # = Accepts an entry (only required if two letters on the same key are
needed - ex: TOM). Pressing # again = Space. (In system programming
mode, use the right arrow Softkey instead to accept and/or add a space.)
CONF Clear the character entry one character at a time.
HOLD Clear all the entries from the point of the flashing cursor and to the right.