10 | P a g e
Finally, click Install to start the installation process.
Post Installation License Check
After the installation process has completed click finish. After clicking finish the license check window
will open. At this point, the MyCalls license will already need to be installed on the SV9100 and the
free license will need to be disabled else MyCalls will not be able to read the license from the switch.
If the license manager is closed without reading the license from the switch then it can be manually
started at any time.
When prompted, enter the IP Address of the SV9100 and click check license. The License check will
then make sure that the free license is disabled on the SV9100 and that there is a MyCalls license
installed on the SV9100.
Once the license has been detected in the PBX, click ‘OK’ and the license manager will start.
To Next Page
Loading...
