48 | P a g e
Enter the name of PC that is acting as the call control server. This is normally the same PC as the
MyCalls server and is running the 3
rd
Party TAPI driver. The call control service is installed by default
when a complete installation of MyCalls is carried out. If the TAPI driver is installed on a different PC
to the MyCalls server then the call control service should be installed onto that PC running TAPI.
Instructions on how install the call control service onto a different PC are provided later on in this
manual. Other configurable items are as follows:
Outside Line Access Code - The outside line access code is the number used to seize a trunk
on the PBX
Number of internal call digits – The number of digits of extensions on the PBX. If MyCalls
dials a number of over this number of digits then the number entered in ‘Outside line access
code’ is added to the dialled number.
Auto Hang-up Calls – If this option is enabled, when a call has finished on the PBX, the phone
will return to an idle state.
Always dial these numbers externally – Any number entered here will always have the
‘Outside line access code’ added when they are dialled.
Click OK the save the changes
To Next Page
Loading...
