Necchi NL11C - Threading The Upper Looper (Red)

11
v
Threading the upper looper (red)
When threading the upper looper, follow the
thread path marked with a red dot.
Open the front cover. Raise the needle to
highest position by turning the hand wheel
toward you. Raise the presser foot. Pass the
thread from back to front through the thread
guide on the thread stand. Use the tweezers
to make the threading easier.
1
Telescopic thread stand
Thread the looper area of the machine
following the red color coded thread guides.
Use the tweezers to make the threading
easier.
Use the tweezers to bring the thread behind
the lower looper and thread into the hole in
the upper looper from front to back.
Pullabout10cm(4″)ofthreadthroughthe
looper and place it to the back of the stitch
plate.
1
-
3
Thread guides
4
Upper looper hole
While holding the thread with both hands,
pass it between the tension discs and pull
it down to make certain it is properly placed
between the tension discs.
1
Tension discs
Pull the thread from right to left under the
upper thread guide.
1
Upper thread guide
1
1
1
3
2
1
4