Necchi NL11C - Replacing the Upper Cutter

39
v
Replacing the upper cutter
n
Attention
Turno󰀨themainpowerswitchandunplug
the machine.
The upper cutter should be changed when
it becomes blunt. Change it by following the
below instructions. If you are having any
di󰀩culties,consultyourserviceagenttomake
the necessary adjustments.
- Place the upper cutter in its lowest
position.
- Turno󰀨theuppercutter.Openthefront
cover.
- Loosen the upper cutter set screw and
remove the upper cutter.
- Place a new upper cutter in the groove
of the upper cutter holder. The front
edge of the upper cutter is approx 0.2-
0.5mm lower than the cutting edge of the
stationary cutter.
- Tighten the upper cutter set screw.
- Turn the upper cutter on again.
1
Non-cutting position
2
Cutting position
3
Upper cutter
4
Upper cutter set screw
5
Lower cutter
Storage
When the machine is not in use, be sure to
keep it unplugged. Store the machine, so it is
not exposed to direct sunlight or humidity.
1
2
0.2-0.5mm
4
5
3