Necchi NL11C - Threading The Lower Looper (Yellow)

12
v
Threading the lower looper
(yellow)
When threading the lower looper, follow the
thread path marked with a yellow dot.
Pass the thread from back to front through
the thread guide on the thread stand. Use the
tweezers to make the threading easier.
1
Telescopic thread stand
Thread the looper area of the machine
following the yellow color coded thread
guides. Use the tweezers to make the
threading easier.
After thread guide, pass the thread from front
to back through the hole in the lower looper.
Pullabout10cm(4")ofthreadthroughthe
looper and place it over the upper looper and
to the back of the stitch plate.
1
-
4
Thread guides
5
Lower looper hole
6
Upper looper
While holding the thread with both hands,
pass it between the tension discs and pull
it down to make certain it is properly placed
between the tension discs.
Turn the hand wheel toward you until the
lower looper is at the far right.
1
Tension discs
Pull the thread from right to left under the
upper thread guide at the back on the top
cover.
1
Upper thread guide
1
1
1
2
3
1
5
4
6