Necta brio 3 - Technician Menu - EVADTS Communication; 5.3.1 Pass Code Configuration; 5.3.2 Security Code Configuration; 5.3.3 Connection Setup

P2595EN01
08 - 2007

39
5.3 - EVADTS
5.3.1 - PASS.CODE
5.3.2 - SECURITY CODE
5.3.3 - CONNECTION
5.3
ev a d t s
The EVADTS (European Vending Association Data Transfer System)
communication protocol has 2 codes for identifying the machine
and for recognising the data transfer terminal.
5.3.1
P
a s s c o d e
It is a four-digit alphanumeric code (0-9; A-F) that must be the same
as the one in the data transfer terminal to allow its identication.
When pressing the conrm button the code is displayed as “0000”
regardless of the actual value; then by pressing the conrm button
the rst digit will start blinking.
Using the scrolling buttons, its value can be changed (during the
change operation the value becomes visible).
Repeat this operation for the 4 digits, after which the value is stored
and the display will indicate “0000” again.
5.3.2
s
e c u r I t y c o d e
It is a further alphanumeric code for reciprocal recognition between
machine and EVADTS terminal.
Programming works as in the “Pass Code”.
5.3.3
c
o n n e c t I o n
This function places the machine in wait mode for connection to
retrieve data.
5.3.4 - MODE
5.3.5 - TYPE
5.3.4
mo d e
This function is used for selecting the communication interface to be
used with the data transfer terminal.
- “IrDA” or “RS232”: for communication with data acquisition devices
- “ALWAYS EVADTS”: for communication with data acquisition and
transmission (e.g. telemetry).
5.3.5
t
y P e
This function is used for setting the communication speed to be
used, between:
- “ENHANCED”: the communication speed is set automatically at
the speed of the slowest device
- “STANDARD 9600bps”: the communication speed is set to
9600bps.