© by N&W GLOBAL VENDING S.p.A. 29 10 2009 3325 - 00
coins reTurned
Used to dene which coins shall be used to give the
change among those available in the tubes. This param-
eter is active only with the coin mechanisms not intend-
ed to manage the choice of the tube in use automatically
(Auto changer payout).
For the coin/value correspondence check the coin
mechanism conguration.
BanknoTes accepTed
Used to dene which banknotes shall be accepted
among those recognised by the reader.
For the banknote/value correspondence check the
reader conguration.
Below-The-level accepTance
Used to dene which coins shall be accepted among
those recognised by the validator when the machine is in
the “exact amount” mode.
For the coin/value correspondence check the coin
mechanism conguration.
Below-The-level BanknoTe accepTance
Used to dene which banknotes shall be accepted
among those recognised by the reader when the ma-
chine is in the “exact amount” mode.
For the banknote/value correspondence check the
reader conguration.
cashless privaTe
To protect the users’ privacy, this function is intended to
display the string “-----” in the place of the credit on the
cashless system.
overpay
You can decide whether to cash or leave the credit ex-
ceeding the selection amount at the user’s disposal.
cash-sale managemenT
Used to give evidence that cash transactions have oc-
curred by means of a cashless system.
The values available are listed here below:
- 0 standard operation: cash transactions are recorded
as such
- 1 forced sending to cashless 1: cash transactions are
recorded as transactions performed by the first cash-
less system
- 2 forced sending to cashless 2: cash transactions are
recorded as transactions performed by the second
cashless system.
parallel machine
Function used to enable the presence of a validator or
parallel bill reader to recharge the keys.
exacT change equaTion
To choose among 15 dierent algorithms to enable the
machine to give the change at the end of the selection.
Every single algorithm checks a series of requirements,
such as the amount of coins in the tubes or the (empty
or full) state of the tubes the coin mechanism will use to
give the change.
If one of these requirements is not fullled, the machine
can supply no change. In this case, the display will show
the “No change” message.
maximum cashless crediT
Function used to set up the maximum credit a cashless
key/card may have to be accepted by the system. If the
key has got a higher value, it will be rejected.
The setup value shall always be higher than or equal to
the value set for the “Maximum cash revalue” function.
If modied and lower, it will be automatically set to the
same value as the “Maximum cash revalue”.
maximum cashless recharge
Used to set up the maximum credit you can charge on a
key or card system.
minimum TuBe level
Used to set a number of coins between 0 and 15 in order
to establish the status of full change tubes and to warn
the user to “insert the exact amount”.
Bill reader funcTion (Bill revalue)
Used to enable the bill reader only to recharge the credit
on the cashless system (key or card).
indefiniTe crediT accepTance
This function is intended to accept cashless payment
systems (key or card) or not if the cashless system credit
is not dened.
groups of users
The function is intended to associate a price list (list 1,
list 2 and list 3) to the groups of users (from 1 to 5).
All groups of users are associated to list 1 by default.