© by N&W GLOBAL VENDING S.p.A. 15 10 2009 3325 - 00
FILLING THE WATER CIRCUIT
If the air-break should signal no water for over 10 sec.
as soon as you power on the machine, the machine will
automatically perform an installation cycle, i.e.:
- the display will show the message “INSTALLATION”
during the whole cycle
- the air-break and the instant boiler are filled in;
- the coffee solenoid valve is opened to bleed the air in
the boiler and let 600 cc water in.
Please Note: If there is no water during the installa-
tion cycle, the machine will stop until the water ow
is restored and the machine is powered o.
The operation shall be carried out manually by using the
special function of the “test” menu in the “Technician”
mode if the (optional) water supply kit from internal
tank is mounted or as a result of any maintenance
operation requiring the operator to empty the boiler and
not the air-break.
saniTising mixers and food circuiTs
for The firsT Time
As soon as you install the machine, carefully disinfect
the mixers, the tubes intended to dispense instant drinks
in order to guarantee the hygiene of dispensed products.
It is absolutely forbidden to use water jets for
cleaning.
Disinfection is carried out by means of sanitising prod-
ucts.
Wash the mixers and add some drops of a sanitising
solution.
After having completed disinfection, rinse the mixers
abundantly to remove any residue of the solution in use.
To dispense water in the mixers, use the “mixer washing”
button. If necessary, enable it from the menu. (see the
relative chapter)
To Next Page
Loading...
Need help?
General
