© by N&W GLOBAL VENDING S.p.A. 2 10 2009 3325 - 00
Introduction
The technical documentation supplied is an integral
part of the equipment and it must therefore accom-
pany the equipment whenever it is either moved
or transferred to enable the various operators to
consult it.
Before starting to install and use the machine, it is nec-
essary to carefully read and understand the content of
the documentation since it can supply important informa-
tion on installation safety, utilisation rules and mainte-
nance operations.
The manual is divided into three chapters.
The rst chapter is intended to describe the ordinary
lling and cleaning operations that shall be carried out
in areas of the machine that can be accessed with the
simple use of the door key, without using any other tool.
The second chapter contains the instructions for correct
installation as well as the information necessary for opti-
mal utilisation of the machine performance.
The third chapter is intended to describe the mainte-
nance operations involving the use of tools for access to
potentially dangerous areas.
The operations described in the second and third
chapter must be carried out only by the person-
nel who have a specic knowledge of the machine
operation from the point of view of electric safety
and health rules.
IDENTIFICATION OF THE MACHINE AND
ITS FEATURES
Every single machine is identied by a specic serial
number that can be found on the rating plate arranged
inside on the right side.
The plate (see gure) is the only one recognised by the
manufacturer and it contains all the data that enable the
manufacturer to supply technical information of any kind
in a quick and safe manner and to facilitate the manage-
ment of spare parts.
IN CASE OF FAILURE
In most cases, any technical problem can be solved by
carrying out minor operations. As a consequence, we
suggest carefully reading this manual before contacting
the manufacturer.
In case of failures or malfunctions that can not be solved,
please apply to:
N&W GLOBAL VENDING SpA
Via Roma 24
24030 Valbrembo
Italy - Tel. +39 035606111
TRANSPORT AND STORAGE
To avoid damaging the machine, loading and unload-
ing operations shall be performed with great care. It is
possible to lift the machine by means of a motor-driven
or manual lift truck by positioning the forks beneath the
machine and on the side clearly stated by the symbol on
the cardboard package.
Please avoid:
- overturning the vending machine;
- dragging the vending machine by means of ropes or
alike;
- lifting the vending machine by its sides;
- lifting the vending machine by means of slings or ropes
- shaking the vending machine and/or the package
For storage it is necessary to keep the room dry at a
temperature between 0 and 40 °C.
Never stack several machines and never forget to keep
the vertical position specied by the arrows on the pack-
age.
Boiler data
Absorbed power
Operating voltage
Model
Product code
Water system features
Current
Frequency
Serial no.
Type
Fig. 1
To Next Page
Loading...
Need help?
General
