5
© by NECTA VENDING SOLUTIONS SpA 09-2003 228 00
osserpsEtnatsnI
snoitceles03rofknirDertil69.0ertil12.1
erutarepmetknirdegarevAC°2.67C°1.67
noitpmusnocrewoP
erutarepmetgnitarepohcaeroThW6,82hW6,82
yb-dnatsh42hW4141hW4141
ruoh/snoitceles03hW2.171hW9.251
)gK(sreniatnocfoyticapaCosserpsEtnatsnI
snaebeeffoC2-
eeffocdetanieffaceddnuorG4.0-
eeffocdetanieffacedtnatsnI-6.0
eeffoctnatsnI-5.0
kliM8.08.0
etalocohC11
allinaVhcnerF4.14.1
CAPACITY OF CONTAINERS
POWER CONSUMPTION
The machine power consumption depends on many fac-
tors, such as the temperature and ventilation of the room
where it is installed, the inlet water and boiler temperature,
etc.
With an ambient temperature of 22° C the following power
consumption levels resulted:
The above power consumption calculated from average
data should only be taken as an indication.
ACCESSORIES
A wide range of accessories can be installed on the
machine to vary its performance:
The installation kits are supplied with their own installation
and test instructions, which must be strictly observed to
ensure the machine safety.
Important notice!!
The use of kits which are not approved by the manufac-
turer of the vending machine does not guarantee compli-
ance with safety standards, especially for energised
parts.
The manufacturer declines all responsibility for the use of
non approved components.
Installation and the following testing operations must
be carried out exclusively by personnel who have a
specific knowledge of the machine functions from a
point of view of electrical safety and health regula-
tions.
The machine installation and the following mainte-
nance operations should be carried out by qualified
personnel only, who are trained in the correct use of
the machine and are aware of the specific risks of such
operations.
The machine must be installed in a dry room with
temperature between 2°C and 32°C.
To energize the system with the open door, simply insert
the special key into the slot (see Fig. 1).
INSTALLATION
The door can be closed only after removing the key.
At installation the hydraulic circuits and the parts in
contact with foodstuff should be fully sanitised to
remove any bacteria which might have formed during
storage.
UNPACKING THE VENDING MACHINE
After removing the packing, ensure that the machine is
intact.
If in doubt do not use the machine.
No packing elements (i.e. plastic bags, polystyrene
foam, nails, etc.) should be left within the reach of
children, as they are potentially dangerous.
Packing materials must be disposed of in authorised
containers and the recyclable ones must be recovered by
qualified companies.
Important notice!!
The machine should be positioned with a maximum
inclination of 2°.
If necessary provide proper levelling by way of the
adjustable feet included (see Fig. 2).
Fig. 1
1 - Door lock bolt
2 - Door lock
3 - Door switch
To Next Page
Loading...
