Nedap AEOS Blue - Page 35

Installation and Configuration | AEOS Blue and vehicle identification EN
Manual version 3 35/48
14. Open the Badge device type editor, select LUMO IP Badge
• The
Port number must match the server port number set in the ANPR LUMO reader,
this example uses port number 12500 (see section 5.1).
• Optionally, you can enter an
allowed host. Typically, this the IP address of the ANPR
LUMO reader.
15. Press CTRL+E and click Yes to deploy the configuration.
16. Close AEmon.
Configuration example