Nedap MPC-2 User Manual

English
MPC -2 27
If the MPC - 2 is set to manual take -off the cow will not be let out of the tandem
box automatically. By pressing the operation key of the exit gate, the cow will
be let out of the tandem box and the cow traffic continues.
If a cow has an attention for milk yield or milk separation, this cow will not be
let out of the tandem box automatically. This is only possible by pressing the
key for the exit gate once.
Blocking gates
You can block the exit gate of the tandem box by pressing the Shift - key and
thereafter the key of the exit gate. The cow can then not leave the tandem box.
The blockade can be lifted by pressing the operation key of the exit gate and
holding it for more than three seconds.
If the last cow has come into the tand em box, the cow traffic can be stopped
with the Shift - key and the key of the central entrance gate. No more cows will
be let in and the gates go the the starting position after the cow has left. After
this the washing can start.
Opening the gate from an other MPC - II (in the same row)
It is also possible to open an exit gate from an other MPC - II by first pressing
the Shift - key and thereafter within 2 seconds the number of the milking place
that should be opened.
Cow in or out the tandem box
Lamp left on: Cow present in the tandem box
Lamp right on: Cow present in passage
Exit blocked
Turn on: Shift + Exit gate
Turn off: 3 seconds Exit gate
Entrance blocked
Turn on: Shift + Entrance gate
Turn off: 3 seconds Entrance gate
Entrance and
exit blocked
Turn on: Shift + Entrance gate and Shift + Exit gate
Turn off: 3 seconds Entrance gate / Exit gate
End of cow traffic during milking
Turn on: Shift + Central entrance gate
Turn off: 3 seconds Central entrance gate
within 2
seconds
within 2
seconds

Nedap MPC-2 Specifications

General

Brand	Nedap
Model	MPC-2
Category	Farm Equipment
Language	English