NVITE | installation guide
33/
4.5.2 Wiegand/magstripe
The Wiegand/Magstripe communication output defines the format of the Wiegand/Magstripe message that is
transmitted upon identification.
If the credential is already programmed in the Wiegand or Magstripe format these settings are not used. The
Wiegand/Magstripe output settings are only used for ID-numbers that are not programmed in the Wiegand or Magstripe
format.
The OSDP firmware does not output any Wiegand or Magstripe messages!
4.5.2.1 Unconfigured
Select unconfigured if the ID-numbers are already programmed in the Wiegand or Magstripe format or if the
Wiegand/Magstripe interface is not used.
4.5.2.2 Wiegand
Select Wiegand to manually configure the Wiegand message output format.
In case the card ID-numbers are already programmed in the Wiegand or Magstripe format, then the below settings will
not be used.
Wiegand output message format:
<P1><prefix><id-src><facility-code><id-number><suffix><P2>
Parity
Enable add parity bits to add a leading and trailing parity bit to the Wiegand message. The leading parity bit (P1) is even
calculated on the first half of the data bits. The trailing parity bit (P2) is odd calculated on the second half of the data
bits. If the number of data bits used in the parity calculation is odd, then the center bit is used in both parity bit
calculations.
Prefix
Constant prefix value. Max. 65,535 (16 bits).
ID-source
If enabled, the ID-source will be sent as an 8-bit code that identifies how the ID-number was read. The ID-source
values can be changed. See chapter 4.3.1.
0 00000000 PROX-LF (120/125 kHz)
1 00000001 BLE
2 00000010 NFC
3 00000011 Barcode
5 00000101 MIFARE
6 00000110 DESFIRE
7 00000111 ISO15693
8 00001000 HID iCLASS
9 00001001 MACE Card
A 00001010 LEGIC
B 00001011 Sony Felica
To Next Page
Loading...
