NVITE | installation guide
30/
4.4.7 Other ID types
The NVITE reader also support reading different RFID card types based upon 13 MHz and 120/125 kHz.
Enable the individual RFID card types as mentioned below.
Nedap XS
Enable reading Nedap XS cards (default enabled).
These tags are programmed with a CF, DF or GF customer code.
Optionally enable the customer code check. See chapter 4.3.1 for more details about Nedap customer codes.
Nedap RW80
Enable reading Nedap RW80 cards.
EM4200
Enable reading EM4200 (and compatible) RFID cards.
HID-PROX
Enable reading HID-PROX cards. HID-PROX cards contain a Wiegand formatted number.
Also HID long format cards are supported (up to max 80 bits).
AWID Proximity/LF
Enable reading AWID Proximity/LF cards. AWID cards contain a Wiegand formatted number.
MACE Card
Enable reading MACE Card, which is a specifically by Nedap programmed DESFIRE EV1 card.
The MACE Cards may be programmed with a Wiegand or Nedap XS formatted number.
HID iCLASS
Enable reading HID iCLASS.
Read access control ID: The access control ID is the Wiegand formatted ID number programmed in the application
area. The reader will automatically perform a secure authentication using the default encryption key.
Read UID: The HID iCLASS UID is a read-only 8-byte unique ID.
ISO15693
Enable reading ISO15693. Reading the UID and/or multiple data blocks is supported. No authentication is performed.
Different RFID cards comply with this standard, for example NXP ICODE SLI(X).
Read UID: The ISO15693 UID is a read-only 8-byte unique ID.
Read multiple blocks is supported for example by NXP ICODE SLI(X) cards.
Configure first block and number of blocks to read. Each block is 4 bytes.
Sony Felica
Enable reading Sony Felica UID. The Sony Felica UID is a read-only 8-byte unique ID.
To Next Page
Loading...
