Need help?Do you have a question about the Nedap VP1006 and is the answer not in the manual?
General| Brand | Nedap |
|---|---|
| Model | VP1006 |
| Category | Card Reader |
| Language | English |
Details on how and where to install the VP1006 unit.
Explains the wiring and connection points for the VP1006.
Verifies the VP1006 has power and initial status via LEDs.
Explains the use and setting of the termination jumper for RS485.
Describes how to set a unique address for each VP1006 on the bus.
Details on checking and tuning the antenna for optimal performance.
Specific instructions for tuning the antenna using an EWA transformer.
How the connected controller software configures the VP1006.
Instructions for testing the VP1006's inputs and outputs.
Covers adjusting antenna power and squelch levels for performance.
Explains various identification test options to verify tag reading.
Explains how indicator LEDs signal errors or malfunctions.
Lists and explains error codes displayed via the "dE" menu option.
Information on how to update the VP1006 firmware.
Notes on cleaning the VP1006 unit.
Guidance on how to properly dispose of the VP1006.
Formal statement of compliance with essential requirements and standards.
Detailed instructions on operating the VP1006 using its display and buttons.
Steps for adjusting the neutrodynisation unit for antenna coupling.
To Next Page
