Nedap NVITE - 4 Reader Configuration; 4.1 Configuration Software

NVITE | installation guide
16/
40
4 Reader configuration
The NVITE reader can be configured easily using the NVITE configuration software. This software tool can be
downloaded from our partner portal https://portal.nedapidentification.com
.
Configuration allows to change:
• General settings.
• Reader settings; what to read and how.
• Communication output settings.
Some settings require expert knowledge. Leave settings unchanged, when their specific meaning is unclear.
It’s always a good practice to save the configuration into a file for future reference or when requesting technical
assistance from Nedap or its business partners.
4.1 Configuration software
The NVITE configuration software allows to configure all settings for the NVITE reader. The software can interface with
the reader using the USB or RS485 interface.
Figure 7: NVITE configuration software
Start the NVITE configuration software and click CONNECT.
Select the following communication parameters and click OK.
• COM-port
• Baud rate
• Communication protocol (STANDARD or OSDP)
• Device address (only for OSDP)
When the connection is established, the software checks the firmware version.
Check the ID List to see what is identified.
Check the Console to see the communication details. For details about the communication protocol refer to the
firmware manual.