Nedap NVITE - 2 Installation; 2.1 Safety Instructions; 2.2 Mounting Instructions

NVITE | installation guide
5/
40
2 Installation
2.1 Safety instructions
The following safety precautions should be observed during normal use, service and repair:
• The NVITE reader may only be installed and serviced by qualified service personnel.
• Disconnect the power supply before (dis)connecting any wires, the reader is NOT hot-swappable, so when making
or changing connections, power must be switched OFF.
• The cable shield shall be connected with safety ground and the metal case of the external device(s).
• To be sure of safety, do not modify or add anything to the reader other than mentioned in this installation guide or
indicated by Nedap.
2.2 Mounting instructions
The NVITE reader can be mounted to any surface, including directly to metal. See the picture below for details about
the dimensions.
Figure 1: NVITE reader dimensions (mm)