NVITE | installation guide
6/
Mount the base-plate on the required location.
Ensure that it is placed correctly covering the cable entry hole.
The cable entry hole must be at least 11mm in diameter.
Properly fix the base-plate into its position using the 2 screws.
When mounting on a stone or concrete wall drill 5mm holes for the plugs.
When mounting on wood, drill with 2.5mm.
Screws and plugs are included.
Install the NVITE reader onto the base-plate:
1. Feed the cable through the cable entry hole. Minimum cable bending radius 30mm.
2. Attach the top of the reader onto the base-plate.
3. Fix the assembly using the screw on the bottom.
Figure 2: NVITE reader installation
To Next Page
Loading...
