Nederman FlexPAK 800 Installation And Service Manual

FlexPAK 800/1000
21
EN
For air consumpon, quality and maximum and minimum pressure, see Secons ‘3.3
Technical data’.
As new ducts may contain dirt, parcles or debris, the compressed air pipe is to be blown
clean before connecng the unit. A compressed air lter, see gure 9, item 9, is to be
installed to ensure the reliable and safe operaon of the unit. A compressed air valve, that
vents the remaining pressure of the unit, is to be installed, see gure 9, item 8.
5.11.2 Installaon
NOTE! Secure the compressed air line properly.
Connect a compressed air supply to the inlet, see gure 4C item 20, and gure
9, item 7.
Air pressure hoses are to be ed together with electrical cables with straps, alternavely
in a common protecve hose. Air pressure hoses are to be anchored mechanically.
6 Maintenance
Read Chapter ‘3 Descripon’ before carrying out any maintenance work. Maintenance
work means that the equipment will have to be opened and possibly dismantled. This may
constute a risk and the maintenance personnel need to know about the risks that may
occur when acng incorrectly.
WARNING! Risk of personal injury.
• The motor, fan and air duct may become very hot during operaon.
• Always use an approved breathing mask, goggles and gloves when replacing the dust
sack and other work that involves exposure to dust.
• Use ear protecon when the unit is in operaon and work is carried out in the vicinity of
the upper secon of the dust collector.
CAUTION! Risk of equipment damage.
During maintenance, it may be necessary to remove the acousc enclosure over the motor
while the motor is in operaon. Take care to prevent objects from falling down into the
motor cooling fan.
NOTE! Always disconnect the supply voltage with the maintenance switch before any
service, whether mechanical or electrical. Always lock the maintenance switch in the o
posion and, if possible, secure with a padlock.
NOTE! Always disconnect the compressed air supply before any service, whether
mechanical or electrical.
NOTE! Contact Nederman if the frequency converter needs service.
NOTE! The unit is CE-marked. Connecons to the unit, inial start-up and maintenance are
to be carried out according to the product manuals..
6.1 Checks one month aer installaon and every year
WARNING! Risk of electric shock.
Always disconnect the supply voltage with the maintenance switch before any service,
whether mechanical or electrical. Always lock the maintenance switch in the o posion.

Nederman FlexPAK 800 Specifications

General

Brand	Nederman
Model	FlexPAK 800
Category	Dust Collector
Language	English