Pos: 26.5.3.2 /Betriebsanleitung/Leerze ile 1pt @ 11\mod_14 79298310216_0.docx @ 212267 @ @ 1
Pos: 26.5.3.3 /Betriebsanleitung/Sicherheitshinweise/Art / Quelle der Gefahr/Dr ehende oder bewegliche Teile! @ 37\mod_155833 1681263_2901.docx @ 32186 9 @ @ 1
Rotating or moving parts!
Pos: 26.5.3.4 /Betriebsanleitung/Leerze ile Halb @ 10\mod_147 8598405587_0.docx @ 20963 7 @ @ 1
Pos: 26.5.3.5 /Betriebsanleitung/Sicherheitshinweise/Konsequenzen bei Missachtung/WARNUNG : Nichtbeachtung kann zu Tod oder sc hweren Verletzungen führen! @ 36\mod_1552634152769_2901.docx @ 31791 3 @ @ 1
Non-compliance can lead to death or serious injury!
Pos: 26.5.3.6 /Betriebsanleitung/Leerze ile Halb @ 10\mod_147 8598405587_0.docx @ 20963 7 @ @ 1
Pos: 26.5.3.7 /Betriebsanleitung/Sicherheitshinweise/Hinweistexte/Störungssuche bei eingeschalteter Energieversorgung @ 39\mod_15 60758261259_2901.docx @ 332093 @ @ 1
As troubleshooting is extremely dangerous when the power supply is switched
on, this method should only be chosen if it is absolutely necessary. Under all
circumstances, it may only be carried out by specially trained and qualified
personnel.
Pos: 26.5.3.8 /Betriebsanleitung/Leerze ile 1pt @ 11\mod_14 79298310216_0.docx @ 212267 @ @ 1
Pos: 26.5.3.9 /Betriebsanleitung/Sicherheitshinweise/Abgrenzungslinie unten @ 36\mod_1552040616240_0.docx @ 317409 @ @ 1
Pos: 26.5.5 /Be triebsanleitung /12 Störungsbehebung/Störungssuche bei eingesc halteter Energieversor gung/Störung en an der Maschine/Anlage @ 29\mod_1517479866270_2901.docx @ 276897 @ @ 1
In case of malfunction of the machine / plant demanding electrical
measurements (e.g. current, tension) or verification of the function of motorized
parts, a fault finding with connected electrical energy sources might be
necessary.
Pos: 26.5.6 /Be triebsanleitung /Leerzeile Halb @ 10\mod_14 78598405587_0.docx @ 209637 @ @ 1
Pos: 26.5.7 /Be triebsanleitung /12 Störungsbehebung/Störungssuche bei eingesc halteter Energieversor gung/Vorgehensweise verursachten Risiken @ 29\mod_1517480965236_2901.docx @ 276925 @ @ 1
In order to minimize the risks involved with such a procedure, at least the
following fundamental safety measures must be gradually taken:
Pos: 26.5.8 /Be triebsanleitung /Leerzeile Halb @ 10\mod_14 78598405587_0.docx @ 209637 @ @ 1
Pos: 26.5.9 /Be triebsanleitung /12 Störungsbehebung/Störungssuche bei eingesc halteter Energieversor gung/Für zusätzliches Personal sorgen @ 29\mod_1517481415977_2901.docx @ 276953 @ @ 1
➔ Call in additional staff whose task it is to activate one of the emergency-off
buttons as soon as there is any danger.
Pos: 26.5.10 /Betriebs anleitung/12 Störungsbeheb ung/Störungssuche bei eingeschalteter Energieversorgung/Schilder mit Warnhinw eis aufstellen @ 29\mod_15 17482181051_2901.docx @ 276981 @ @ 1
➔ Put up signs with the warning “NO ACCESS - REPAIR/MAINTENANCE
WORK WHILE PLANT RUNNING”.
Pos: 26.5.11 /Betriebs anleitung/12 Störungsbeheb ung/Störungssuche bei eingeschalteter Energieversorgung/Maschine/Anlage elektrisch freischalten (-> Kapitel „Sicherheitshinweise") @ 29\mod_1517485584145_2901.docx @ 277037 @ @ 1
➔ Disconnect and isolate the machine / plant from the power supply (→
section “Safety instructions”).
Pos: 26.5.12 /Betriebs anleitung/12 Störungsbeheb ung/Störungss uche bei eingeschalteter Energieversorgung/So wenige Schutzeinrichtungen wie erforderlich entfernen @ 29\mod_1 517488840764_2901.docx @ 277065 @ @ 1
➔ Remove as few protective facilities as necessary.
Pos: 26.5.13 /Betriebs anleitung/12 Störungs behebung/Störungss uche bei eingeschalteter Energieversorgung/Bevor die Maschine/Anlage wieder eingeschaltet wird @ 30\mod_151 7489015989_2901.docx @ 277093 @ @ 1
➔ Before you switch the machine / plant on again, make sure that nobody is in
the danger zone.
Pos: 26.5.14 /Betriebs anleitung/12 Störungsbeheb ung/Störungssuche bei eingeschalteter Energieversorgung/Maschine/Anlage wieder einschalten @ 30\mod_15 17492600168_2901.docx @ 277141 @ @ 1
➔ Switch the machine / plant on again and make the necessary observations
at a safe distance from all moving and live components.
Pos: 26.5.15 /Betriebs anleitung/12 Störungsbeheb ung/Störungssuche bei eingeschalteter Energieversorgung/Maschine/Anlage wieder ausschalten @ 30\mod_1517492997585_2901.docx @ 277169 @ @ 1
➔ Switch the machine / plant off again.
Pos: 26.5.16 /Betriebs anleitung/12 Störungsbeheb ung/Störungssuche bei eingeschalteter Energieversorgung/Maschine/Anlage elektrisch freischalten (-> Kapitel „Sicherheitshinweise") @ 29\mod_1517485584145_2901.docx @ 277037 @ @ 1
➔ Disconnect and isolate the machine / plant from the power supply (→
section “Safety instructions”).
Pos: 26.5.17 /Betriebs anleitung/12 Störungsbeheb ung/Störungssuche bei eingeschalteter Energieversorgung/Die notwendige Reparatur druchführen @ 30\mod_15 17493875096_2901.docx @ 277197 @ @ 1
➔ Carry out the necessary repairs and install all safety and protective facilities
again.
Pos: 26.5.18 /Betriebs anleitung/12 Störungsbeheb ung/Störungssuche bei eingeschalteter Energieversorgung/Die Maschine/Anlage überprüfen @ 30\mod_1517494303620_2901.docx @ 277225 @ @ 1
➔ Check the machine / plant and the safety system for function ability. We
would point out once again that the machine / plant may only be operated
with all the safety system components in working order.
Pos: 26.6 /Betriebsa nleitung/Leerzeile Halb @ 10\mod_14 78598405587_0.docx @ 209637 @ @ 1
Pos: 26.7.1 /Be triebsanleitung /Übersc hriften/1.1/12 Störungsbeh ebung/Checklisten bei Störung en @ 20\mod_1491985001507_2901.docx @ 231309 @ @ 1
12.3 Checklists in event of faults
Pos: 26.7.2 /Be triebsanleitung /Leerzeile Halb @ 10\mod_14 78598405587_0.docx @ 209637 @ @ 1
Pos: 26.7.3.1 /Betriebsanleitung/Sicherheitshinweise/Warnsymbo le mit Signalwo rt/HINWEIS @ 32\mod_152645 3032777_2901.docx @ 28860 9 @ @ 1