64
Problem Possible cause Remedy
. . . if the appliance no longer Demo mode active, To deactivate the demo mode, touch
heats up and the colon on the heating elements locked. the
*
and
(
buttons for 5 seconds.
clock flashes?
. . . if the appliance cannot be Lock or childproof lock To deactivate, touch the
(
and
/
operated and Controls locked active (see ”Safety buttons for 3 seconds. Controls
is indicated on the display? features”). locked goes out.
. . . if the appliance cannot be Permanent lock or To deactivate, touch the
*
and
)
operated and Permanent lock childproof lock active buttons for 6 seconds. Permanent
is indicated on the display? (see ”Safety features”). Lock goes out.
. . . if not possible flashes on The oven has not cooled Wait until the oven has cooled down.
the display after the operating down fully, e.g. due to Then restart the operating mode.
mode was switched on? prolonged use of the
oven.
. . . if your appliance has Appliance has Continue using the oven by rotating the
automatically switched off and automatically switched roller or selecting another operating
the temperature display off to prevent overheating mode.
000 flashes? (see ”Safety features”).
. . . if smoke is generated during Roasting temperature
roasting or grilling? to high.
Wire shelf or universal Place wire shelf into universal pan and
pan slid in incorrectly. insert together in shelf position.
. . . if liquids or thin viscous The appliance has not Level the appliance using the leveling
dough are distributed at a been placed or installed feet, or check the installation.
visibly uneven thickness? plumb-and-level.
. . . if the oven shows increasing Normal occurrence, Briefly open the oven door occasionally
condensation water? e.g. in the case of cakes during baking or roasting, wipe up the
with very moist topping condensation water after operation.
(fruit) or roasts.
To Next Page
