EasyManuals Logo

NEFF B58VT68H0 User Manual

NEFF B58VT68H0
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
Steam en
19
5. Take out the cover (Fig. #).
Note: Whether or not there is a cover depends on
the appliance type.
6. Fill the water tank with cold water up to the "max."
mark (Fig. $).
7. Put the cover back into the opening on the water
tank.
8. Insert the filled water tank (Fig. %). Ensure that the
water tank locks into place behind both holders ƒ
(Fig. &).
9. Slowly slide the control panel downwards and then
push it towards the rear until it is closed completely.
The water tank has been filled. You can start using
operating modes with steam.
Refilling the water tank
Notes
Steam-assisted operations continue without adding
steam.
If the water tank runs dry during operation with the
Dough proving or Reheat settings, operation is
interrupted. Fill the water tank.
1. Open the control panel.
2. Remove and refill the water tank.
3. Insert the filled water tank and close the control
panel.
After every steam operation
:Warning – Risk of scalding!
When you open the appliance door, hot steam can
escape. Steam may not be visible, depending on its
temperature. When opening, do not stand too close to
the appliance. Open the appliance door carefully. Keep
children away.
:Warning – Risk of burns!
The appliance becomes hot during operation. Allow the
appliance to cool down before cleaning.
Caution!
Enamel damage: Do not start any operations when
there is water on the cooking compartment floor. Before
operation, wipe away the water from the cooking
compartment floor.
The remaining water is pumped back into the water
tank after every operation with steam. Then empty and
dry the water tank. Moisture remains in the cooking
compartment. To dry the cooking compartment, you
can either use the "Drying ª" operating mode or dry the
cooking compartment by hand.
Notes
Once the appliance has been switched off, the
touch button remains lit for a little longer to remind
you to empty the water tank.
Remove limescale marks with a cloth soaked in
vinegar, then wipe with clean water and dry with a
soft cloth.
Emptying the water tank
Caution!
Do not dry the water tank in the hot cooking
compartment. This will damage the water tank.
Do not clean the water tank in the dishwasher. This
will damage the water tank.
1. Open the control panel.
2. Remove water tank.
3. Carefully remove the lid of the water tank.
4. Empty the water tank, clean it with detergent and
then rinse it thoroughly with clean water.
5. Dry all parts with a soft cloth.
6. Rub the seal on the lid until dry.
7. Leave to dry with the lid open.
8. Place the lid on the water tank and push it down.
9. Insert the water tank and close the control panel.
Starting drying
To dry the cooking compartment, it is heated up so that
the moisture in the cooking compartment evaporates.
You will then need to open the appliance door to allow
the steam to escape from the cooking compartment.
Caution!
Enamel damage: Do not start any operations when
there is water on the cooking compartment floor. Before
operation, wipe away the water from the cooking
compartment floor.
1. Allow the appliance to cool down.
2. Remove the worst of the food remnants from the
cooking compartment immediately and use a
sponge to wipe away moisture from the cooking
compartment floor.
3. If necessary, touch the # touch button to switch the
appliance on.
4. Touch the 0 field to display the operating modes.
5. On the touch display, swipe to the left or right to
select "Dry ª".
6. Touch the line at the bottom.
The duration will be displayed. It cannot be changed.
7. Touch the line at the bottom.
D
E
E
I

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NEFF B58VT68H0 and is the answer not in the manual?

NEFF B58VT68H0 Specifications

General IconGeneral
Oven sizeMedium
Oven typeElectric
Cleaning typePyrolytic
Pyrolyze power4800 W
Number of ovens1
Total oven power- W
Microwave cooking-
Oven thermostat range40 - 275 °C
Auto programs quantity18
Number of shelf positions4
Number of cooking programs14
Total oven(s) interior capacity71 L
Maximum temperature (convection)275 °C
Maximum temperature (conventional)200 °C
Current16 A
Connected load3600 W
AC input voltage220 - 240 V
Energy efficiency index (EEI)87.1
Energy consumption (conventional)0.9 kWh
Energy consumption (forced convection)0.74 kWh
Door hingedown
Cord length1.2 m
Control typeTouch
Display typeTFT
Door materialGlass
Product colorBlack, Stainless steel
Control positionFront
Display diagonal5.7 \
Interior materialStainless steel
Appliance placementBuilt-in
Water tank capacity1 L
Door temperature (max)30 °C
Effective tray surface area1290 cm²
Lamp typeLED
Lamps quantity1 lamp(s)
Weight and Dimensions IconWeight and Dimensions
Depth548 mm
Width596 mm
Height595 mm
Weight46882 g
Depth with door open635 mm
Installation compartment depth550 mm
Installation compartment width560 mm
Installation compartment height585 mm
Interior dimensions (W x D x H)480 x 415 x 357 mm

Related product manuals