en Cleaning function
34
Cancelling
Touch the # touch button to cancel. The appliance
door cannot be opened until the 5 symbol goes out.
Finishing
As soon as self-cleaning has run through, a signal
sounds. The appliance door cannot be opened until the
5 symbol goes out.
Once the cleaning function has ended
1. Allow the cooking compartment to cool down.
2. Wipe off any ash that has been left behind in the
cooking compartment and around the appliance
door with a damp cloth.
3. If you have left an accessory inside the cooking
compartment to be cleaned, remove it and wipe it
down with a damp cloth.
4. Lift the accessory support up at the front and remove
it. ~ "Rails" on page 36
5. Refit the shelf supports or pull-out rails. ~ "Rails"
on page 36
EasyClean
The EasyClean cleaning aid makes it easier to clean the
cooking compartment. Dirt is softened beforehand by
vaporizing soapy water. It can then be removed more
easily.
:Warning – Risk of scalding!
Water in a hot cooking compartment may create hot
steam. Never pour water into the cooking compartment
when the cooking compartment is hot.
Starting
Notes
■ The "EasyClean š" cleaning aid can only be started
once the cooking compartment is cold (room
temperature) and the appliance door is closed.
■ Do not open the appliance door during operation.
Doing this will interrupt the "EasyClean š" cleaning
aid.
1. Remove the accessories from the cooking
compartment.
2. Mix a drop of washing-up liquid into 0.4 litres of
water (do not use distilled water) and pour it onto the
centre of the cooking compartment floor.
3. Touch the # touch button.
4. Touch the 0 touch button.
5. Swipe to the left or right to select "EasyClean š".
6. Touch the bottom line.
7. Touch the # touch button.
The appliance starts EasyClean. The remaining time
appears on the display.
End
As soon as the cleaning aid has run through, a signal
sounds and the appliance ends the operation
automatically.
As soon as you open the appliance door, the interior
lighting is switched on so that you can rinse the cooking
compartment more easily. The remaining water in the
cooking compartment must be removed promptly. Do
not leave the remaining water in the cooking
compartment for a long time (e.g. overnight). The
appliance must not be operated when the cooking
compartment is still wet or damp.
Subsequent cleaning
1. Open the appliance door and remove the remaining
water with an absorbent sponge cloth.
2. Clean the smooth surfaces in the cooking
compartment with a dish cloth or a soft brush.
Stubborn residues can be removed using a stainless
steel scouring pad.
3. Remove limescale with a cloth soaked in vinegar.
Then wipe with clean water and rub dry with a soft
cloth (including under the door seal).
4. Use the # touch button to switch off the appliance.
5. Leave the appliance door ajar in the stop position
(approx. 30°) for approx. one hour to allow the
enamel surfaces in the cooking compartment to dry
thoroughly. Alternatively, you can also run the rapid
drying function for the cooking compartment.
Running the rapid drying function for the cooking
compartment
1. After the cleaning aid has been run through, leave
the appliance door ajar in the stop position (approx.
30°).
2. Touch the # touch button.
3. Start CircoTherm hot air at 50 °C.
4. After five minutes, switch off the appliance and close
the appliance door.
Removing heavy deposits of dirt
You have several options for removing particularly
stubborn deposits of dirt.
■ Leave the soapy water to work for some time before
starting the cleaning aid.
■ Rub soapy water onto the dirt on the smooth
surfaces before starting the cleaning aid.
■ Repeat the cleaning aid after the cooking
compartment has cooled down.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
