Rails en
43
pRails
Rails
Detaching the shelf supports
The shelf supports are each fixed to the side panels of
the cooking compartment at three points.
1. Grip the front of the shelf support and pull it round to
the middle of the cooking compartment.
The front hook of the shelf support will come out of
the hole.
2. Swing the shelf support round further and pull it out
of the rear holes in the side panel.
3. Remove the shelf supports from the cooking
compartment.
Refitting the shelf supports
1. Insert the hooks of the shelf support into the rear
holes in the side panel.
2. Push the front hook of the shelf support into the
hole.
qAppliance door
Ap p l i a n c e door
With good care and cleaning, your appliance will retain
its appearance and remain fully functional for a long
time to come. This will tell you how to clean the
appliance door.
Removing and installing the door panels
To facilitate cleaning, you can remove the glass panels
from the oven door.
Removing the door panels
1. Open the oven door fully.
2. Lock both hinges on the left and right using the
locking pin.
Note: The locking pins must be fully inserted into the
holes in the hinges.
3. Lift the bottom of the inner panel slightly until the
fastening pins come out of the holder (1).
4. Carefully lift the top of the inner panel until the
fastening pins come out of the holder (2).
Caution!
When lifting the inner panel, the middle panel may
stick to the inner panel. Make sure that the middle
panel does not fall.
D
E
To Next Page
Loading...
Need help?
General