6 IJ25 Postage Meter User's Guide
INTRODUCTION
In order to achieve the best impression, your IJ25 requires an even surface on which to
print, therefore on bulky or uneven items correct folding of the contents will help
considerably.
It is sometimes unavoidable that your mail will contain staples, paper clips and other
fixings. The machine will accept these, but it is recommended that the fixings are situated
at the bottom of the envelope. This will avoid the risk of damage to your printing
head.
In the event that a satisfactory print cannot be achieved due to bulky contents (Max. 3/
8 inch) the envelope should be treated as a packet and a label used.
GETTING STARTED
Set the switch on the power supply outlet to the OFF position, connect the power unit to
the power supply outlet and the other end to the D.C. input socket ( ) at the back of
the machine.
Now set the switch on the power outlet socket to ON.
When the machine is ready, the following displays will be observed:
To Log On
To unlock the machine, enter User PIN.
Notes: If using the machine for the first time, the
Factory default PIN is set to1234.
To change the PIN, please see page 25.
Enter PIN, e.g.1234
Press:
.
If an incorrect PIN is entered, check PIN for
accuracy, press
and try again.
WELCOME TO IJ25
PLEASE WAIT . .
LOCKED
09:01 12/12/00
PRINTING POSTAGE
Followed by
LOCKED
----
Ready $0.00
12/12/00