20
Initial Warm-Up Session
Turn on the device by pressing main ON/OFF
button.
Close the hood of the equipment and switch
on the steam sauna (STEAM) function from
the upper control panel. The following icon
will appear on the screen in a small frame.
Select the maximum steam temperature by
pressing +/- buttons until the steam icon
appears in the frame. Set temperature to
48º. The timer will automatically set itself to
30 minutes.
After the steam session has stopped, switch
on the infrared sauna (INFRARED) function
from upper control panel. The following icon
will appear on the screen in a small frame.
Select the maximum infrared temperature
by pressing +/- buttons until display shows
50º C. The timer will automatically set itself
to 30 minutes.
Fill the tub with water, closing the tub drain
first by sliding the drainage valve into the
left-side position.
Open the cold and the hot water taps. When
the water level reaches ~ 1 cm above the
back jets, close the water inlet. Now switch
on all the hydrotherapy functions of the tub
from the lower control panel for 5 minutes:
Close the hood of the equipment and turn on
the first program of the Vichy shower
(VICHY SHOWER) for 5 minutes.
Empty the tub and aerate the equipment
(turn on air blower for 1 minute - water will
be thrown out from the bottom jets). Now
the equipment is ready to use. In case any
of the functions will not operate please
contact the local dealer.
To Next Page
Loading...