44
Infrared Sauna
NB! The infrared sauna should only be
taken on the vibrating bed!
Place the vibrating bed onto the bath tub
and plug in the power cord into the backside
of the equipment.
NB! Infrared sauna and Vichy shower
functions cannot work at the same time.
WARNING! Do not let water contact
the IR heating element – it can damage
the lamp.
After the warm-up cycle the cocoon’s hood
can be opened and the client can lie down
onto the vibrating table. The cocoon hood
should be closed slowly and carefully.
Place a special piece of cloth onto the
opened area near the client’s head. The
Neck Cloth will prevent excessive steam
escaping from the cocoon during treatment.
Neck Cloth is available in NeoQi® supporting
products range.
To activate Infrared sauna function, press
the INFRARED button on the Control Panel
A.
Infrared indicator will appear on the screen
surrounded by a circle. (You will feel heat
after few minutes).
To select desirable temperature, press the
+/- buttons on control panel A, while the
infrared indicator is surrounded by a circle.
You will see the temperature on the display.
NeoQi® energy cocoon will automatically
maintain this temperature level.
Temperature can be modified throughout
the session. For that, you must hold your
finger for at least 2 seconds on the
INFRARED button, infrared indicator will be
surrounded by a circle and you can adjust
the temperature by pressing the +/-
buttons.
The temperature must be selected according
to the individual needs of each person and
we recommend to use a lower temperature
setting for the first sessions. The most
commonly used temperature is between 38-
42ºC.
It is important to communicate with the
client throughout the session to ensure that
the selected temperature is comfortable.
If you open the hood of cocoon during the
session, the infrared function will remain on.
NB! Infrared function must be turned
off when opening the hood!
To turn off the function, press the
INFRARED button.
To Next Page
Loading...