Net.Do FOX512 - Copy Step; Delete Program; Copy Program; PLAYBACK of Program

Net.DO Lighting Control Equipment Co.,Ltd http://www.netdo.com.cn
FOX512 Moving Light Controller. PAGE: 26
*TIPS1: use   Cursor Key to select menu item, use  Cursor Key to modify item;
*TIPS2: “Single-Step Program” just needs to be edited 1 step. “Multi-Step Program” can be added
new steps. The console will automatically copy the last step to the new one in order for a
coherent chase, data of current step can be cleared by pressing CLEAR if it’s unwanted.
*TIPS3：use  SETP  key to check data of every step, modified data will be saved automatically.
*TIPS4：new step can be added after current step by pressing NewStep soft key at the current step.
*TIPS5：current step can be deleted by pressing DEL Step soft key.
9.5.1 Copy Step
Operation of copying step is as follow.
 Copy a whole program to the next step of current step:
E.g.: copy Program1.01 to the next step of Step3 in Program1.02:
1）In EditStep menu, select Step3 in Program1.02;
2）Press and hold COPY  Press Playback Key of Program1.01 to finish copying.
 Copy single step --- this function have to be achieved by the assistance of SCENE.
E.g.: Copy Step9 in Program1.01 to Step10 in Program1.02;
1）In EditStep menu, select Step9 in Program1.01 and record it to a SCENE
2）Select Step10 in Program1.02 in EditStep menu, then call the SCENE just recorded.
9.6 Delete Program
Operation of deleting the whole program is as follow:
Press and hold DELETE key  Press Playback Key of the program to finish deleting.
9.7 Copy Program
Copy a program to another, the operation is as follow:
Press and hold COPY key  Press Playback Key(source)  Press another Playback
Key(target); select Playback Page Key first if the target is in another page.
9.8 PLAYBACK of Program
Push up Playback Fader or press Playback Key to run the corresponding program.
TIPS1: Press CLEAR firstly to ensure there is no data of Manual-Run to affect the playback running.
TIPS2: Ensure Master Faders of Playback and Grand are pushed up before running playback to
avoid no output of Dimmer.
 Up to 8 playbacks can run at the same time.
 All HTP channels will follow playback faders
to fade in/out. LTP channels will instantly
start(LTP-inst) once the playback fader is
pushed, it can also be set to follow playback
fader to fade in(LTP-fade)
9.8.1 Turn Pages of Playback
Turn pages of playbacks by Playback Page Key. Press and hold the key for fast turning.
TIPS: Playback fader that pushed up will keep outputting after page is turned, the program of the
same fader in the new page will not be output until the fader is pulled down to 0 and pushed up again.
Status Current Step Value of fader/HTP/LTP
Program No. Total Steps Running Mode