Net.Do FOX512 - 10 Scene

Net.DO Lighting Control Equipment Co.,Ltd http://www.netdo.com.cn
FOX512 Moving Light Controller. PAGE: 30
10. SCENE
There are totally 2 pages (A / B) for SCENE, up to 20 scenes can be saved in each page. Switch
page by SCENE A / B Function Key, select Scene Number by pressing 1~20 Numeric Key.
10.1 Edit SCENE
 Record Scene:
1) Manual-Run to edit lighting effects; (Superimpose and run multiple saved scenes or playbacks
also can do);
2) Press and hold RECORD  (Select fixtures)  Press Scene Numeric Key to finish recording;
*TIPS: Step in parentheses ( ) can be skipped, if it’s skipped, data of all fixtures will be recorded.
Attribute can also be chosen to record:
Press and hold RECORD  (Select single or multiple attribute by Attribute Key)
 Press Scene Numeric Key to finish recording;
*TIPS: if select attribute, the console will only record the modified data of the selected attribute.
Create scene material through this method for scenes superimposed.
 Delete Scene:
Press and hold DELETE  Press Scene Numeric Key to finish deleting;
 Copy Scene:
Press and hold COPY  Press Scene Numeric Key (source)
 Press another Scene Numeric Key (target);
(The target Scene Numeric Key can be in another page)
 Check Scene:
Press and hold RECORD, the indicator above the Scene Numeric Key will be bright if there is
data saved in it.
10.2 Run SCENE
Switch Pages by pressing SCENE A / B Function Key，select Scenes to run by 1~20 Numeric Key.
*TIPS1: Press and hold SCENE A / B Function Key for 2 seconds to stop the output of all Scenes.
*TIPS2: When the indicator of A / B Function Key is bright, it means the corresponding page is
currently selected. When the indicator flashes slowly, it means there are Scenes in that
page outputting.
*TIPS3: It’s very convenient to make various lighting effects by superimposing Playbacks and
Scenes.
Modes of Scene Numeric Key:
 Scenes in Page A are of LATCH mode, which means multiple scenes can be output
together;
 No.1~10 Scenes in Page B are of FLASH mode;
 No.11~20 Scenes in Page B are of SWOP mode, only 1 scene can be output at the same
time.