Net2Edge PB-TDM1-CONTRA - Configuration Menu; Configuration > CES > Port Settings

Transition Networks Contra Converter Quick Setup Guide
Configuration Menu
Navigate to Configuration > CES > Port Settings to configure the Contra Converter’s TDM ports.
Configuration > CES > Port Settings
This page shows the configuration of the TDM ports.
The Contra Ports parameters are described below.
Port
The TDM port number.
Port type
The type of the Port (DTE - Terminal or DCE - Network).
Shutdown Connections on Failure
Check the checkbox to elect to close connections when a failure occurs.
Buttons
Save: Click to save the new configuration for the Port(s).
Reset: Click to reset the new configuration back to the current configuration.
33604 Rev. A www.transition.com Page 11 of 72