Transition Networks Contra Converter Quick Setup Guide
Initial Configuration / Setup
1. Local IP Address/Subnet Mask/Default Gateway
Contra Converter can initially be connected to using either CLI or via web browser using the default
IP settings. Please see the Contra Converter Install Guide manual for details on how to connect via
one of these methods.
If connected via the Web GUI, go to Configuration > System > IP and configure the details to match
those provided by your Network Administrator.
Click Save when this is complete.
If connected via the CLI, the command for setting the IP details is as follows:
ip setup [<ip_addr>] [<ip_mask>] [<ip_router>]
The first option is the IP Address, the second is the Subnet Mask and the third is the Default
Gateway. Type ? for a full list of commands. Please see the related CLI Reference manual for more
information on using the CLI.
33604 Rev. A www.transition.com Page 6 of 72
To Next Page
Loading...