Transition Networks Contra Converter Quick Setup Guide
CLI Command Summary
Login and Help (?) Commands
Telnet HyperTerminal
login as: admin
admin@172.16.20.74's password:
Welcome to the Command Line Interface (v1.0).
Type 'help' or '?' to get help.
>help
General Commands:
-----------------
Help/?: Get help on a group or a specific command
Up : Move one command level up
Logout: Exit CLI
Command Groups:
---------------
System : System settings and reset options
Conf : Configuration management
Loop : Loop Protection
IP : IP configuration and Ping
Port : Port management
MAC : MAC address table
VLAN : Virtual LAN
PVLAN : Private VLAN
Security : Security management
STP : Spanning Tree Protocol
Aggr : Link Aggregation
LACP : Link Aggregation Control Protocol
LLDP : Link Layer Discovery Protocol
Thermal : Thermal Protection
QoS : Quality of Service
Mirror : Port mirroring
Firmware : Download of firmware via TFTP
MVR : Multicast VLAN Registration
Loop Protect: Loop Protection
IPMC : MLD/IGMP Snooping
sFlow : sFlow Agent
VCL : VLAN Control List
CES : CES Settings
Type '<group>' to enter command group, e.g. 'port'.
Type '<group> ?' to get list of group commands, e.g. 'port ?'.
Type '<command> ?' to get help on a command, e.g. 'port mode ?'.
Commands may be abbreviated, e.g. 'por co' instead of 'port configuration'.
>
33604 Rev. A www.transition.com Page 41 of 72
To Next Page
Loading...