Net2Edge PB-TDM1-CONTRA - CES Port Commands

Transition Networks Contra Converter Quick Setup Guide
CES Port Commands
CES port configuration [<port>]
CES port setup <port> [dce|dte] [yes|no]
CES port status [<port>]
CES port loop [<port>] [local|remote] [enable|disable]
CES port break calls <port>
Command: CES Port Config
Syntax: ces port config [<port>]
Description: Show the TDM port configuration for the specified port or for all ports, where:
<port>: TDM Port Number to be displayed.
Example: Display the current CES port setup:
>ces port conf
CONTRA PORT 1 CONFIGURATION
===========================
Port type : DTE
Shutdown Connections on Failure : No
>
Command: CES Port Setup
Syntax: ces port setup <port> [dce|dte] [yes|no]
Description: Update the config for a Contra port and display the new config, where:
<port> : TDM Port Number.
dce|dte: Contra port type of DCE or DTE.
yes|no : Whether to shutdown a connection on failure.
Example: Change the config to Port Type = DTE and shutdown connection on failure:
>ces port setup 1 DCE yes
CONTRA PORT 1 CONFIGURATION
===========================
Port type : DCE
Shutdown Connections on Failure : Yes
>
33604 Rev. A www.transition.com Page 44 of 72