Net2Edge PB-TDM1-CONTRA - Page 45

Transition Networks Contra Converter Quick Setup Guide
Command: Show CES Port Status
Syntax: ces port status [<port>]
Description: Display the current CES port status.
Example: Display the current status for CES port 1:
>ces port status 1
TDM Port 1 Status
==================
Port State : CONTRA DCE
>ces port status 2
Invalid parameter: 2
Syntax:
CES port status [<port>]
>
Command: Set CES Port Loop Config
Syntax: ces port loop [<port>] [local|remote] [enable|disable]
Description: Displays or sets the CES port loopback function, where:
<port> : TDM Port Number
local|remote : Type of loop, local or remote
enable|disable: Whether to enable or disable the loop
Example: Enable the Local loopback config for port 1 and display the resulting config:
>ces port loop 1 local enable
TDM Port 1, Local Loop has been Enabled
>
Command: Break CES port calls
Syntax: CES port break calls <port>
Description: Resets all connections on a port immediately, where:
<port>: TDM Port Number.
Example: Terminate all active connections on TDM port 1:
>ces port break calls 1
All Active Connections on TDM Port 1, have been terminated.
>
33604 Rev. A www.transition.com Page 45 of 72