Transition Networks Contra Converter Quick Setup Guide
Command: Turn CES Debug Mode On
Syntax: CES debug on [all|tdm|link|control|arp|sip|llcont|llglob] [<value>]
Description: Turn on debug for a specified category, where:
all|tdm|link|control|arp|sip|llcont|llglob: Specific Debug type (category).
<value> : Debug Value
Example 1: Turn on Debug mode globally:
>ces debug on
CES Debug settings
==================
TDM 1 Interface : OFF
Logical Link 1 : OFF
Logical Link 2 : OFF
Logical Link 3 : OFF
Logical Link 4 : OFF
Logical Link 5 : OFF
Logical Link 6 : OFF
Logical Link 7 : OFF
Logical Link 8 : OFF
Logical Link 9 : OFF
Logical Link 10 : OFF
Logical Link 11 : OFF
Logical Link 12 : OFF
Logical Link 13 : OFF
Logical Link 14 : OFF
Logical Link 15 : OFF
Logical Link 16 : OFF
Control : OFF
ARP : OFF
SIP : OFF
LL Control : OFF
LL Global : OFF
>
33604 Rev. A www.transition.com Page 67 of 72
To Next Page
Loading...