Steps
1. From the menu bar of the StorageGRID Appliance Installer, click Configure Networking >
Link Configuration.
The Network Link Configuration page displays a diagram of your appliance with the network
and management ports numbered.
The Link Status table lists the link state (up/down) and speed (1/10/25/40/100 Gbps) of the
numbered ports.
The first time you access this page:
• Link Speed is set to 10GbE.
• Port bond mode is set to Fixed.
• Network bond mode for the Grid Network is set to Active-Backup.
• The Admin Network is enabled, and the network bond mode is set to Independent.
• The Client Network is disabled.
Hardware Installation and Maintenance Guide for SG5700 Appliances 35
Configuring the hardware
To Next Page
Loading...
Need help?
General
