The Client Network settings for the 10/25-GbE ports are now shown.
4. Refer to the table, and configure the port bond mode and the network bond mode.
The example shows:
• Aggregate and LACP selected for the Grid and the Client networks. You must specify a
unique VLAN tag for each network. You can select values between 0 and 4095.
• Active-Backup selected for the Admin Network.
5. When you are satisfied with your selections, click Save.
Note: You might lose your connection if you made changes to the network or link you are
connected through. If you are not reconnected within 1 minute, re-enter the URL for the
StorageGRID Appliance Installer using one of the other IP addresses assigned to the
appliance:
Hardware Installation and Maintenance Guide for SG5700 Appliances 37
Configuring the hardware
To Next Page
Loading...
Need help?
General
