When the appliance is in maintenance mode, a confirmation message lists the URLs you
can use to access the StorageGRID Appliance Installer.
f. Browse to any of the URLs displayed.
Note: If possible, use the URL containing the IP address of the appliance's Admin
Network port.
Note: Accessing https://169.254.0.1:8443 requires a direct connection to the
local management port.
g. Confirm that the appliance is in maintenance mode by noting the maintenance mode
message on the StorageGRID Appliance Installer home page.
2. Select Configure Networking > Link Configuration from the menu.
3. Make the desired changes to the link configuration.
For more information on the options, see "Configuring network links."
4. When you are satisfied with your selections, click Save.
Note: You might lose your connection if you made changes to the network or link you are
connected through. If you are not reconnected within 1 minute, re-enter the URL for the
Hardware Installation and Maintenance Guide for SG5700 Appliances 82
Maintaining the SG5700 appliance
To Next Page
Loading...
Need help?
General
